Cisco 300 Series User Manual

Quality of Service (QoS) Commands
OL-32830-01 Command Line Interface Reference Guide 756
39
• permit-any—Forward all the packets (which were ingress of the port) that
do not meet the rules in a policy.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Default
Policy map is not bound.
User Guidelines
This command is only available in QoS advanced mode.
Only one policy map per interface per direction is supported.
Examples
The following example attaches a policy map called Policy1 to the input interface.
switchxxxxxx(config-if)# service-policy input policy1
The following example attaches a policy map called Policy1 to the input interface
and forwards all packets that do not meet the rules of the policy.
switchxxxxxx(config-if)# service-policy input policy1 permit-any
39.14 qos aggregate-policer
Use the qos aggregate-policer Global Configuration mode command to define the
policer parameters that can be applied to multiple traffic classes. Use the no form
of this command to remove an existing aggregate policer.
Syntax
qos aggregate-policer
aggregate-policer-name committed-rate-kbps
committed-burst-byte
[exceed-action action ]
no qos aggregate-policer
aggregate-policer-name

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48