Cisco 300 Series

DHCP Server Commands
OL-32830-01 Command Line Interface Reference Guide 292
12
switchxxxxxx(config-dhcp)# netbios-name-server 10.12.1.90
12.15 netbios-node-type
To configure the NetBIOS node type for Microsoft DHCP clients, use the
netbios-node-type command in DHCP Pool Network Configuration mode or in
DHCP Pool Host Configuration mode. To return to default, use the no form of this
command.
Syntax
netbios-node-type {b-node | p-node | m-node | h-node}
no netbios-node-type
Parameters
• b-node—Specifies the Broadcast NetBIOS node type.
• p-node—Specifies the Peer-to-peer NetBIOS node type.
• m-node—Specifies the Mixed NetBIOS node type.
• h-node—Specifies the Hybrid NetBIOS node type.
Command Mode
DHCP Pool Network Configuration mode
DHCP Pool Host Configuration mode
Default Configuration
h-node (Hybrid NetBIOS node type).
Example
The following example specifies the client's NetBIOS type as mixed.
switchxxxxxx(config-dhcp)# netbios node-type m-node