Cisco 300 Series User Manual

Link Layer Discovery Protocol (LLDP) Commands
657 OL-32830-01 Command Line Interface Reference Guide
30
Default Configuration
Disabled.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example enables sending LLDP notifications on gi11.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# lldp notifications enable
30.14 lldp notifications interval
To configure the maximum transmission rate of LLDP notifications, use the lldp
notifications interval Global Configuration mode command. To return to the default,
use the no form of this command.
Syntax
lldp notifications interval
seconds
no lldp notifications interval
Parameters
interval
seconds —The device does not send more than a single notification in the
indicated period (range: 5–3600).
Default Configuration
5 seconds
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# lldp notifications interval 10

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48