Cisco 300 Series

RADIUS Commands
795 OL-32830-01 Command Line Interface Reference Guide
40
no radius-server deadtime
Parameters
• deadtime —Specifies the time interval in minutes during which a RADIUS
server is skipped over by transaction requests. (Range: 0–2000).
Default Configuration
The default deadtime interval is 0.
Command Mode
Global Configuration mode
Example
The following example sets all RADIUS server deadtimes to 10 minutes.
switchxxxxxx(config)# radius-server deadtime 10
40.8 show radius-servers
Use the show radius-servers Privileged EXEC mode command to display the
RADIUS server settings.
Syntax
show radius-servers
Command Mode
Privileged EXEC mode
Example
The following example displays RADIUS server settings:
switchxxxxxx# show radius-servers
IP address Port Port Time Dead
Auth Acc Out Retransmision time Priority Usage
---------- ---- ---- ---- ------------- ------ -------- -----