Cisco 300 Series User Manual

RADIUS Commands
OL-32830-01 Command Line Interface Reference Guide 794
40
40.6 radius-server timeout
Use the radius-server timeout Global Configuration mode command to set how
long the device waits for a server host to reply. Use the no form of this command to
restore the default configuration.
Syntax
radius-server timeout
timeout-seconds
no radius-server timeout
Parameters
• timeout timeout-seconds —Specifies the timeout value in seconds. (Range:
1–30).
Default Configuration
The default timeout value is 3 seconds.
Command Mode
Global Configuration mode
Example
The following example sets the timeout interval on all RADIUS servers to 5
seconds.
switchxxxxxx(config)# radius-server timeout 5
40.7 radius-server deadtime
Use the radius-server deadtime Global Configuration mode command to
configure how long unavailable RADIUS servers are skipped over by transaction
requests. This improves RADIUS response time when servers are unavailable. Use
the no form of this command to restore the default configuration.
Syntax
radius-server deadtime
deadtime

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48