Cisco 300 Series

Quality of Service (QoS) Commands
OL-32830-01 Command Line Interface Reference Guide 774
39
Example 5—This is an example of the output from show qos interface policer
Example 6—This is an example of the output from show qos interface rate-limit
switchxxxxxx(config)# show qos interface rate-limit gi1 1
Port rate-limit [kbps] Burst [Bytes]
---------- ----------------- -------------
gi1 1 3000 3000
39.27 qos map policed-dscp
Use the qos map policed-dscp Global Configuration mode command to configure
the policed-DSCP map for remarking purposes. Use the no form of this command
to restore the default configuration.
switchxxxxxx(config)# show qos interface policer gi1 1
Ethernet gi11
Class map: A
Policer type: aggregate
Commited rate: 192000 bps
Commited burst: 9600 bytes
Exceed-action: policed-dscp-transmit
Class map: B
Policer type: single
Commited rate: 192000 bps
Commited burst: 9600 bytes
Exceed-action: drop
Class map: C
Policer type: none
switchxxxxxx(config)# show qos interface rate-limit gi11
Port
-----
gi11
rate-limit [kbps]
-----------------
1000
Burst [Bytes]
--------------
512