Link Layer Discovery Protocol (LLDP) Commands
665 OL-32830-01 Command Line Interface Reference Guide
30
30.23 show lldp configuration
To display the LLDP configuration for all ports or for a specific port, use the show
lldp configuration Privileged EXEC mode command.
Syntax
show lldp configuration
[interface-id | detailed
]
Parameters
• interface-id—(Optional) Specifies the port ID.
• detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Default Configuration
Display for all ports. If detailed is not used, only present ports are displayed.
Command Mode
Privileged EXEC mode
Examples
Example 1 - Display LLDP configuration for all ports.
switchxxxxxx#
show lldp configuration
State: Enabled
Timer: 30 Seconds
Hold multiplier: 4
Reinit delay: 2 Seconds
Tx delay: 2 Seconds
Notifications interval: 5 seconds
LLDP packets handling: Filtering
Port State Optional TLVs Address Notifications
-------- ----- -------------- ----------- ------------
gi11 RX,TX PD, SN, SD, SC 172.16.1.1 Disabled
To Next Page
Loading...
