Cisco 300 Series

System Management Commands
975 OL-32830-01 Command Line Interface Reference Guide
50
Parameters
connection—(Optional) Specifies the connection number. (Range: 1-4
connections.)
Default Configuration
The default connection number is that of the most recent connection.
Command Mode
Privileged EXEC mode
Example
The following command switches to open Telnet session number 1.
switchxxxxxx> resume 1
50.5 service cpu-input-rate
The show cpu input rate Global Configuration mode command enables counting
the rate of input frames to the CPU in packets per seconds (pps).
Syntax
service cpu-input-rate
Parameters
This command has no arguments or keywords.
Command Mode
Global Configuration mode
Example
The following example displays CPU input rate information.
switchxxxxxx(config)# service cpu-input-rate