Cisco 300 Series

Address Table Commands
149 OL-32830-01 Command Line Interface Reference Guide
5
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Before defining forbidden ports, the Multicast group should be registered.
You can execute the command before the VLAN is created.
Example
The following example registers IP address 239.2.2.2, and forbids the IP address
on port gi14 within VLAN 8.
switchxxxxxx(config)# interface vlan 8
switchxxxxxx(config-if)# bridge multicast ip-address 239.2.2.2
switchxxxxxx(config-if)# bridge multicast forbidden ip-address 239.2.2.2 add
gi14
5.7 bridge multicast source group
To register a source IP address - Multicast IP address pair to the bridge table, and
statically add or remove ports to or from the source-group, use the bridge
multicast source group Interface (VLAN) Configuration mode command. To
unregister the source-group-pair, use the no form of this command.
Syntax
bridge multicast source
ip-address group ip-multicast-address [[add | remove]
{ethernet interface-list | port-channel port-channel-list}]
no bridge multicast source ip-address group ip-multicast-address
Parameters
• ip-address—Specifies the source IP address.
• ip-multicast-address—Specifies the group IP Multicast address.
• add—(Optional) Adds ports to the group for the specific source IP address.
• remove—(Optional) Removes ports from the group for the specific source
IP address.