Cisco 300 Series User Manual

Link Layer Discovery Protocol (LLDP) Commands
645 OL-32830-01 Command Line Interface Reference Guide
30
Syntax
lldp chassis-id
{mac-address | host-name}
no lldp chassis-id
Parameters
• mac-address—Specifies the chassis ID to use the device MAC address.
• host-name—Specifies the chassis ID to use the device configured host
name.
Default Configuration
MAC address.
Command Mode
Global Configuration mode
User Guidelines
The host name should be configured to be a unique value.
If the chassis ID configured to be used in LLDP packets is empty, LLDP uses the
default chassis ID (specified above).
Example
The following example configures the chassis ID to be the MAC address.
switchxxxxxx(config)# lldp chassis-id mac-address
30.3 lldp hold-multiplier
To specify how long the receiving device holds a LLDP packet before discarding it,
use the lldp hold-multiplier Global Configuration mode command. To restore the
default configuration, use the no form of this command.
Syntax
lldp hold-multiplier
number
no lldp hold-multiplier

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48