Cisco 300 Series User Manual

Clock Commands
OL-32830-01 Command Line Interface Reference Guide 246
9
User Guidelines
Use the sntp server Global Configuration mode command to define SNTP servers.
Example
The following example enables the device to use SNTP Unicast clients.
switchxxxxxx(config)# sntp unicast client enable
9.19 sntp unicast client poll
To enable polling for the SNTP Unicast clients, use the sntp unicast client poll
command in Global Configuration mode. To disable the polling, use the no form of
this command.
Syntax
sntp unicast client poll
no sntp unicast client poll
Parameters
N/A
Default Configuration
Polling is disabled.
Command Mode
Global Configuration mode
User Guidelines
The polling interval is 1024 seconds.
Example
The following example enables polling for SNTP unicast clients.
switchxxxxxx(config)# sntp unicast client poll

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48