Cisco 300 Series User Manual

Link Layer Discovery Protocol (LLDP) Commands
OL-32830-01 Command Line Interface Reference Guide 662
30
Parameters
reinit
seconds —Specifies the minimum time in seconds an LLDP port waits before
reinitializing LLDP transmission.(Range: 1–10)
Default Configuration
2 seconds
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# lldp reinit 4
30.20 lldp timer
To specify how often the software sends LLDP updates, use the lldp timer Global
Configuration mode command. To restore the default configuration, use the no
form of this command.
Syntax
lldp timer
seconds
no lldp timer
Parameters
timer
seconds —Specifies, in seconds, how often the software sends LLDP
updates (range: 5-32768 seconds).
Default Configuration
30 seconds.
Command Mode
Global Configuration mode

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48