Cisco 300 Series

Quality of Service (QoS) Commands
OL-32830-01 Command Line Interface Reference Guide 760
39
switchxxxxxx(config-pmap)# class class1
switchxxxxxx(config-pmap-c)# police aggregate policer1
switchxxxxxx(config-pmap-c)# exit
switchxxxxxx(config-pmap)# exit
switchxxxxxx(config)# policy-map policy2
switchxxxxxx(config-pmap)# class class2
switchxxxxxx(config-pmap-c)# police aggregate policer1
39.17 wrr-queue cos-map
Use the wrr-queue cos-map Global Configuration mode command to map Class of
Service (CoS) values to a specific egress queue. Use the no form of this command
to restore the default configuration.
Syntax
wrr-queue cos-map
queue-id cos0 ... cos7
no wrr-queue cos-map [ queue-id ]
Parameters
• queue-id—Specifies the queue number to which the CoS values are
mapped.
• cos0... cos7—Specifies up to 8 CoS values to map to the specified queue
number. (Range: 0–7)
Default Configuration
The default CoS value mapping to 8 queues is as follows:
CoS value 0 is mapped to queue 1.
CoS value 1 is mapped to queue 2.
CoS value 2 is mapped to queue 3.
CoS value 3 is mapped to queue 6.
CoS value 4 is mapped to queue 5.
CoS value 5 is mapped to queue 8.