Cisco 300 Series

Address Table Commands
OL-32830-01 Command Line Interface Reference Guide 172
5
Example
The following example sets the port to limited learning mode:
switchxxxxxx(config)# interface gi14
switchxxxxxx(config-if)# port security mode max
switchxxxxxx(config-if)# port security max 20
switchxxxxxx(config-if)# port security
switchxxxxxx(config-if)# exit
5.25 port security routed secure-address
To add a MAC-layer secure address to a routed port. (port that has an IP address
defined on it), use the port security routed secure-address Interface (Ethernet,
Port Channel) Configuration mode command. To delete a MAC address from a
routed port, use the no form of this command.
Syntax
port security routed secure-address
mac-address
no port security routed secure-address mac-address
Parameters
mac-address—Specifies the MAC address.
Default Configuration
No addresses are defined.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode. It cannot be configured for
a range of interfaces (range context).
User Guidelines
This command enables adding secure MAC addresses to a routed port in port
security mode. The command is available when the port is a routed port and in
port security mode. The address is deleted if the port exits the security mode or is
not a routed port.