Cisco 300 Series User Manual

Quality of Service (QoS) Commands
OL-32830-01 Command Line Interface Reference Guide 758
39
Policing uses a token bucket algorithm. CIR represents the speed with which the
token is added to the bucket. CBS represents the depth of the bucket.
This command does not work in Layer 3 mode.
Examples
Example 1. The following example defines the parameters of a policer called
policer1 that can be applied to multiple classes in the same policy map. When the
average traffic rate exceeds 124,000 kbps or the normal burst size exceeds 9600
bytes, the packet is dropped.
switchxxxxxx(config)# qos aggregate-policer policer1 124000 9600
exceed-action drop
39.15 show qos aggregate-policer
Use the show qos aggregate-policer Privileged EXEC mode mode command to
display aggregate policers
This command is only available in QoS advanced mode.
Syntax
show qos aggregate-policer [
aggregate-policer-name ]
Parameters
aggregate-policer-name—Specifies the aggregate policer name.
Default Configuration
All policers are displayed.
Command Mode
Privileged EXEC mode
Examples
The following example displays the parameters of the aggregate policer called
Policer1.
switchxxxxxx# show qos aggregate-policer policer1

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48