Cisco 300 Series User Manual

802.1X Commands
OL-32830-01 Command Line Interface Reference Guide 70
2
Default Configuration
The silence period is not limited.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The command is only applied to WEB-based authentication.
If an authorized client does not send traffic during the silence period specified by
the command, the state of the client is changed to unauthorized.
Example
The following example sets the authentication silence time to 100 seconds:
switchxxxxxx(config)# interface gi1 1
switchxxxxxx(config-if)# dot1x timeout silence-period 100
2.24 dot1x timeout supp-timeout
Use the dot1x timeout supp-timeout Interface Configuration mode command to
set the time interval during which the device waits for a response to an Extensible
Authentication Protocol (EAP) request frame from the client before resending the
request. Use the no form of this command to restore the default configuration.
Syntax
dot1x timeout supp-timeout
seconds
no dot1x timeout supp-timeout
Parameters
• supp-timeout seconds —Specifies the time interval in seconds during
which the device waits for a response to an EAP request frame from the
client before resending the request. (Range: 1–65535 seconds).
Default Configuration
The default timeout period is 30 seconds.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48