Cisco 300 Series

IPv6 First Hop Security
OL-32830-01 Command Line Interface Reference Guide 518
25
25.25 ipv6 nd inspection attach-policy (VLAN
mode)
To attach an ND Inspection policy to a specified VLAN, use the ipv6 nd inspection
attach-policy command in VLAN Configuration mode. To return to the default, use
the no form of this command.
Syntax
ipv6 nd inspection attach-policy
policy-name
no ipv6 nd inspection attach-policy
Parameters
• policy-name —The ND Inspection policy name (up to 32 characters).
Default Configuration
The ND Inspection default policy is applied.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Use this command to attach a ND Inspection policy to a VLAN.
If the policy specified by the policy-name
argument is not defined, the command
is rejected.
Use the no form of the command to detach the current policy and to reattach the
default policy. The no form of the command does not have an effect if the default
policy was attached.
Example
In the following example, the ND Inspection policy policy1 is attached to VLAN
100:
switchxxxxxx(config)# interface vlan 100
switchxxxxxx(config-if)# ipv6 nd inspection attach-policy policy1
switchxxxxxx(config-if)# exit