Cisco 300 Series User Manual

IPv6 First Hop Security
565 OL-32830-01 Command Line Interface Reference Guide
25
Command Mode
Neighbor Binding Policy Configuration mode.
User Guidelines
If this command is part of a policy attached to a VLAN, it is applied to all the ports
in the VLAN. If it is defined in a policy attached to a port in the VLAN, this value
overrides the value in the policy attached to the VLAN.
Examples
Example 1—The following example defines an Neighbor Binding policy named
policy1, places the router in Neighbor Binding Policy Configuration mode, and
limits the number of IPv6 addresses allowed on the port to 25:
switchxxxxxx(config)# ipv6 neighbor binding policy policy1
switchxxxxxx(config-nbr-binding)# max-entries interface-limit 25
switchxxxxxx(config)# exit
Example 2—The following example defines an RA Guard policy named policy1,
places the switch in RA Guard Policy Configuration mode, and disables limit per
MAC:
switchxxxxxx(config)# ipv6 nd raguard policy policy1
switchxxxxxx(config-ra-guard)# max-entries mac-limit disable
switchxxxxxx(config-ra-guard)# exit
25.60 other-config-flag
To enable the verification of the advertised the Other Configuration flag in RA
messages within an IPv6 RA Guard policy, use the other-config-flag command in
RA Guard Policy Configuration mode. To return to the default, use the no form of
this command.
Syntax
other-config-flag {on | off
| disable}
no other-config-flag

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48