Cisco 300 Series User Manual

DHCP Server Commands
OL-32830-01 Command Line Interface Reference Guide 290
12
12.13 lease
To configure the time duration of the lease for an IP address that is assigned from a
DHCP server to a DHCP client, use the lease command in DHCP Pool Network
Configuration mode. To restore the default value, use the no form of this command.
Syntax
lease
days [ hours [ minutes ]] | infinite
no lease
Parameters
• days —Specifies the number of days in the lease.
• hours —(Optional) Specifies the number of hours in the lease. A days value
must be supplied before configuring an
hours value.
• minutes —(Optional) Specifies the number of minutes in the lease. A days
value and an
hours value must be supplied before configuring a minutes
value.
• infinite—Specifies that the duration of the lease is unlimited.
Default Configuration
The default lease duration is 1 day.
Command Mode
DHCP Pool Network Configuration mode
Examples
The following example shows a 1-day lease.
switchxxxxxx(config-dhcp)# lease 1
The following example shows a one-hour lease.
switchxxxxxx(config-dhcp)# lease 0 1

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48