Cisco 300 Series User Manual

CDP Commands
OL-32830-01 Command Line Interface Reference Guide 208
8
8.9 cdp log mismatch voip
Use the cdp log mismatch voip Global and Interface Configuration mode
command to enable validating that the VoIP status of the port received in a CDP
packet matches its actual configuration. If not, a SYSLOG message is generated
by CDP. The no format of the CLI command disables the generation of the
SYSLOG messages.
Syntax
cdp log mismatch voip
no cdp log mismatch voip
Parameters
N/A
Default Configuration
The switch reports VoIP mismatches from all ports.
Command Mode
Global Configuration mode
Interface (Ethernet) Configuration mode
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# cdp log mismatch voip
8.10 cdp log mismatch native
Use the cdp log mismatch native Global and Interface Configuration mode
command to enable validating that the native VLAN received in a CDP packet
matches the actual native VLAN of the port. If not, a SYSLOG native mismatch
message is generated. The no format of the CLI command disables the generation
of the SYSLOG messages.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48