Cisco 300 Series User Manual

DHCP Server Commands
291 OL-32830-01 Command Line Interface Reference Guide
12
The following example shows a one-minute lease.
switchxxxxxx(config-dhcp)# lease 0 0 1
The following example shows an infinite (unlimited) lease.
switchxxxxxx(config-dhcp)# lease infinite
12.14 netbios-name-server
To configure the NetBIOS Windows Internet Naming Service (WINS) server list that
is available to Microsoft DHCP clients, use the netbios-name-server in DHCP Pool
Network Configuration mode or in DHCP Pool Host Configuration mode. To
remove the NetBIOS name server list, use the no form of this command.
Syntax
netbios-name-server
ip-address [ ip-address2 ... ip-address8 ]
no netbios-name-server
Parameters
• ip-address [ ip-address2 ... ip-address8 ]—Specifies the IP addresses of
NetBIOS WINS name servers. Up to eight addresses can be specified in
one command line.
Command Mode
DHCP Pool Network Configuration mode
DHCP Pool Host Configuration mode
Default Configuration
No bios server is defined.
Example
The following example specifies the IP address of a NetBIOS name server
available to the DHCP client.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48