Cisco 300 Series User Manual

SYSLOG Commands
OL-32830-01 Command Line Interface Reference Guide 966
49
Parameters
• hostname—The system hostname will be used as the message origin
identifier.
• IP—IP address of the sending interface that is used as the message origin
identifier.
• IPv6—IPv6 address of the sending interface that is used as the message
origin identifier. If the sending interface is IPv4, the IPv4 address will be
used instead.
• string user-defined-id —Specifies an identifying description chosen by the
user. The
user-defined-id argument is the identifying description string.
Default Configuration
No header is sent apart from the PRI field.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# logging origin-id string “Domain 1, router B ”
49.15 show logging
To display the logging status and SYSLOG messages stored in the internal buffer,
use the show logging Privileged EXEC mode command.
Syntax
show logging
Parameters
This command has no arguments or keywords.
Default Configuration
None

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48