Ethernet Configuration Commands
413 OL-32830-01 Command Line Interface Reference Guide
18
18.24 show errdisable recovery
To display the Err-Disable configuration of the device, use the show errdisable
recovery Privileged EXEC mode command.
Syntax
show errdisable recovery
Parameters
This command has no arguments or keywords.
Default Configuration
None
Command Mode
Privileged EXEC mode
Example
The following example displays the Err-Disable configuration.
switchxxxxxx#
show errdisable recovery
Timer interval: 300 Seconds
Reason Automatic Recovery
---------------------- ------------------
port-security Disable
dot1x-src-address Disable
acl-deny Enable
stp-bpdu-guard Disable
stp-loopback-guard Disable
loop-detection Disable
udld Disable
To Next Page
Loading...
