Cisco 300 Series User Manual

Link Layer Discovery Protocol (LLDP) Commands
OL-32830-01 Command Line Interface Reference Guide 670
30
Syntax
show lldp local tlvs-overloading
[interface-id]
Parameters
interface-id—(Optional) Specifies a port ID.
Default Configuration
If no port ID is entered, the command displays information for all ports.
Command Mode
User EXEC mode
User Guidelines
The command calculates the overloading status of the current LLDP configuration,
and not for the last LLDP packet that was sent.
Example
switchxxxxxx# show lldp local tlvs-overloading gi11
TLVs Group Bytes Status
------------ ------ --------------
Mandatory 31 Transmitted
LLDP-MED Capabilities 9 Transmitted
LLDP-MED Location 200 Transmitted
802.1 1360 Overloading
Total: 1600 bytes
Left: 100 bytes
30.26 show lldp med configuration
To display the LLDP Media Endpoint Discovery (MED) configuration for all ports or
for a specific port, use the show lldp med configuration Privileged EXEC mode
command.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48