Configuration and Image File Commands
267 OL-32830-01 Command Line Interface Reference Guide
10
ssd file passphrase control unrestricted
no ssd file integrity control
ssd-control-end cb0a3fdb1f3a1af4e4430033719968c0
!
no spanning-tree
interface range gi11-4
speed 1000
exit
no lldp run
interface vlan 1
ip address 1.1.1.1 255.0.0.0
exit
line console
exec-timeout 0
exit
switchxxxxxx#
10.10 show bootvar
Use the show bootvar EXEC mode command to display the active system image
file that was loaded by the device at startup, and to display the system image file
that will be loaded after rebooting the switch.
Syntax
show bootvar
show bootvar [unit
unit-id
]
Parameters
This command has no arguments or keywords.
Command Mode
User EXEC mode
To Next Page
Loading...
