Cisco 300 Series User Manual

IPv6 Commands
OL-32830-01 Command Line Interface Reference Guide 630
27
IPv6 Address Age Link-layer Addr State Interface Router
2000:0:0:4::2 0 0003.a0d6.141e REACH VLAN1 Yes
Field Descriptions:
• Total number of entries—Number of entries (peers) in the cache.
• IPv6 Address—IPv6 address of neighbor or interface.
• Age—Time (in minutes) since the address was confirmed to be reachable. A
hyphen (-) indicates a static entry.
• Link-layer Addr—MAC address. If the address is unknown, a hyphen (-) is
displayed.
• Interface—Interface which the neighbor is connected to.
• Router—Specifies if the neighbor is a Router. A hyphen (-) is displayed for
static entries.
27.16 show ipv6 route
Use the show ipv6 route command in user EXEC or privileged EXEC mode to
display the current contents of the IPv6 routing table.
Syntax
show ipv6 route [
ipv6-address | ipv6-prefix/prefix-length | protocol | interface
interface-id ]
Parameters
• ipv6-address —Displays routing information for a specific IPv6 address.
This argument must be in the form documented in RFC4293 where the
address is specified in hexadecimal using 16-bit values between colons.
• ipv6-prefix —Displays routing information for a specific IPv6 network. This
argument must be in the form documented in RFC4293 where the address
is specified in hexadecimal using 16-bit values between colons.
• / prefix-length —The length of the IPv6 prefix. A decimal value that indicates
how many of the high-order contiguous bits of the address comprise the
prefix (the network portion of the address). A slash mark must precede the
decimal value.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48