Cisco 300 Series User Manual

Network Management Protocol (SNMP) Commands
867 OL-32830-01 Command Line Interface Reference Guide
45
If notifyview is not specified, the notify view is not defined.
If
readview is not specified, all objects except for the community-table and
SNMPv3 user and access tables are available for retrieval.
If
writeview is not specified, the write view is not defined.
Command Mode
Global Configuration mode
User Guidelines
The group defined in this command is used in the snmp-server user command to
map users to the group. These users are then automatically mapped to the views
defined in this command.
The command logical key is (groupname, snmp-version, security-level). For
snmp-version v1/v2 the security-level is always noauth.
Example
The following example attaches a group called
user-group to SNMPv3, assigns
the encrypted security level to the group, and limits the access rights of a view
called
user-view to read-only. User tom is then assigned to user-group . So that
user
tom has the rights assigned in user-view .
switchxxxxxx(config)# snmp-server group user-group v3 priv read user-view
switchxxxxxx(config)# snmp-server user tom user-group v3
45.8 show snmp views
To display SNMP views, use the show snmp views Privileged EXEC mode
command.
Syntax
show snmp views [
viewname ]
Parameters
viewname—(Optional) Specifies the view name. (Length: 1–30 characters)

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48