Cisco 300 Series User Manual

Address Table Commands
OL-32830-01 Command Line Interface Reference Guide 158
5
5.13 bridge multicast ipv6 forbidden source
group
To forbid adding or removing a specific IPv6 source address - Multicast address
pair to or from specific ports, use the bridge multicast ipv6 forbidden source
group Interface (VLAN) Configuration mode command. To return to the default
configuration, use the no form of this command.
Syntax
bridge multicast ipv6 forbidden
source ipv6-source-address group
ipv6-multicast-address {add | remove} {ethernet interface-list | port-channel
port-channel-list}
no bridge multicast ipv6 forbidden source ipv6-address group
ipv6-multicast-address
Parameters
• ipv6-source-address—Specifies the source IPv6 address.
• ipv6-multicast-address—Specifies the group IPv6 Multicast address.
• add—Forbids adding ports to the group for the specific source IPv6
address.
• remove—Forbids removing ports from the group for the specific source
IPv6 address.
• ethernet interface-list —Specifies a list of Ethernet ports. Separate
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
• port-channel port-channel-list —Specifies a list of port channels. Separate
nonconsecutive port-channels with a comma and no spaces; use a hyphen
to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.
Command Mode
Interface (VLAN) Configuration mode

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48