Cisco 300 Series User Manual

802.1X Commands
69 OL-32830-01 Command Line Interface Reference Guide
2
Default Configuration
The default timeout period is 30 seconds.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The actual timeout period can be determined by comparing the value specified by
this command to the result of multiplying the number of retries specified by the
radius-server retransmit command by the timeout period specified by the
radius-server retransmit command, and selecting the lower of the two values.
Example
The following example sets the time interval between retransmission of packets to
the authentication server to 3600 seconds.
switchxxxxxx(config)# interface gi1 1
switchxxxxxx(config-if)# dot1x timeout server-timeout 3600
2.23 dot1x timeout silence-period
To set the authentication silence time, use the dot1x timeout silence-period
command in Interface Configuration mode. The silence time is the number of
seconds that if an authorized client does not send traffic during this period, the
client is changed to unauthorized
To return to the default setting, use the no form of this command.
Syntax
dot1x timeout silence-period
seconds
no dot1x timeout silence-period
Parameters
• seconds —Specifies the silence interval in seconds. The valid range is 60 -
65535.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48