Cisco 300 Series User Manual

DHCP Server Commands
OL-32830-01 Command Line Interface Reference Guide 302
12
12.23 show ip dhcp excluded-addresses
To display the excluded addresses, use the show ip dhcp excluded-addresses
command in User EXEC mode.
Syntax
show ip dhcp excluded-addresses
Command Mode
User EXEC mode
Example
The following example displays excluded addresses.
switchxxxxxx# show ip dhcp excluded-addresses
The number of excluded addresses ranges is 2
Excluded addresses:
10.1.1.212- 10.1.1.219, 10.1.2.212- 10.1.2.219
12.24 show ip dhcp expired
To display the specific expired address or all of the expired addresses on the
DHCP server, use the show ip dhcp expired command in User EXEC mode.
Syntax
show ip dhcp expired [
ip-address ]
Parameters
• ip-address —(Optional) Specifies the IP.
Command Mode
User EXEC mode
Example

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48