Cisco 300 Series

Ethernet Configuration Commands
391 OL-32830-01 Command Line Interface Reference Guide
18
switchxxxxxx(config-if)#
Example 3—The following example shuts down vlan 100.
switchxxxxxx(config)# interface vlan 100
switchxxxxxx(config-if)# shutdown
switchxxxxxx(config-if)#
Example 4—The following example shuts down tunnel 1.
switchxxxxxx(config)# interface tunnel 1
switchxxxxxx(config-if)# shutdown
switchxxxxxx(config-if)#
Example 5—The following example shuts down Port Channel 3.
switchxxxxxx(config)# interface po3
switchxxxxxx(config-if)# shutdown
switchxxxxxx(config-if)#
18.4 operation time
To control the time that the port is up, use the operation time Interface (Ethernet,
Port Channel) Configuration mode command. To cancel the time range for the port
operation time, use the no form of this command.
Syntax
operation time
time-range-name
no operation time