Cisco 300 Series

Macro Commands
OL-32830-01 Command Line Interface Reference Guide 692
32
switchxxxxxx(config-if)# macro description dup
switchxxxxxx(config-if)# macro description duplex
switchxxxxxx(config-if)# end
switchxxxxxx(config)# exit
switchxxxxxx# show parser macro description
Global Macro(s):
Interface Macro Description(s)
------------ --------------------------------------------------
gi12 dup
gi13 duplex | dup | duplex
--------------------------------------------------------------
switchxxxxxx# configure
switchxxxxxx(config)# interface gi12
switchxxxxxx(config-if)# no macro description
switchxxxxxx(config-if)# end
switchxxxxxx(config)# exit
switchxxxxxx# show parser macro description
Global Macro(s):
Interface Macro Description(s)
--------- -----------------------------------------------------
gi13 duplex | dup | duplex
32.4 macro global
Use the macro global Global Configuration command to apply a macro to a switch
(with or without the trace option).
Syntax
macro global {apply | trace}
macro-name [ parameter-name1 value ]
[
parameter-name2 value ] [parameter -name3 value ]