Cisco 300 Series User Manual

SYSLOG Commands
959 OL-32830-01 Command Line Interface Reference Guide
49
Example
The following example limits logging messages displayed on the console to
messages with severity level errors.
switchxxxxxx(config)# logging console errors
49.7 logging file
To limit SYSLOG messages sent to the logging file to messages with a specific
severity level, use the logging file Global Configuration mode command. To cancel
sending messages to the file, use the no form of this command.
Syntax
logging file
level
no logging file
Parameters
level—Specifies the severity level of SYSLOG messages sent to the logging file.
The possible values are: emergencies, alerts, critical, errors, warnings,
notifications, informational and debugging.
Default Configuration
The default severity level is errors.
Command Mode
Global Configuration mode
Example
The following example limits SYSLOG messages sent to the logging file to
messages with severity level alerts.
switchxxxxxx(config)# logging file alerts

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48