Cisco 300 Series User Manual

DHCP Server Commands
289 OL-32830-01 Command Line Interface Reference Guide
12
Command Mode
Global Configuration mode
User Guidelines
During execution of this command, the configuration mode changes to DHCP Pool
Network Configuration mode. In this mode, the administrator can configure pool
parameters, such as the IP subnet number and default router list.
Example
The following example configures Pool1 as the DHCP address pool.
switchxxxxxx(config)# ip dhcp pool network Pool1
switchxxxxxx(config-dhcp)#
12.12 ip dhcp server
To enable the DHCP server features on the device, use the ip dhcp server
command in Global Configuration mode. To disable the DHCP server, use the no
form of this command.
Syntax
ip dhcp server
no ip dhcp server
Default Configuration
The DHCP server is disabled.
Command Mode
Global Configuration mode
Example
The following example enables the DHCP server on the device:
switchxxxxxx(config)# ip dhcp server

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48