Cisco 300 Series

Smartport Commands
855 OL-32830-01 Command Line Interface Reference Guide
44
44.17 smartport storm-control broadcast
enable
Use the smartport storm-control broadcast enable Interface Configuration
(Ethernet, port-channel) mode command to enable storm control on a Smartport
port. Use the no form of this command to disable storm control..
Syntax
smartport storm-control broadcast enable
Parameters
This command has no arguments or keywords.
Default Configuration
None
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# smartport storm-control broadcast enable
44.18 smartport storm-control broadcast level
Use the smartport storm-control broadcast level Interface Configuration (Ethernet,
port-channel) mode command to control the amount of Broadcast traffic allowed
on an interface.
Syntax
smartport storm-control broadcast level {
level | kbps kbps }
no smartport storm-control broadcast level