Cisco 300 Series

CDP Commands
209 OL-32830-01 Command Line Interface Reference Guide
8
Syntax
cdp log mismatch native
no cdp log mismatch native
Parameters
N/A
Default Configuration
The switch reports native VLAN mismatches from all ports.
Command Mode
Global Configuration mode
Interface (Ethernet) Configuration mode
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# cdp log mismatch native
8.11 cdp device-id format
The cdp device-id format Global Configuration mode command specifies the
format of the Device-ID TLV. The no format of this command returns to default.
Syntax
cdp device-id format {mac | serial-number | hostname}
no cdp device-id format
Parameters
• mac—Specifies that the Device-ID TLV contains the device’s MAC address.
• serial-number—Specifies that Device-ID TLV contains the device’s
hardware serial number.
• hostname—Specifies that Device-ID TLV contains the device’s hostname.