IPv6 Commands
OL-32830-01 Command Line Interface Reference Guide 612
27
Default Configuration
No default gateway is defined.
Command Mode
Global Configuration mode
User Guidelines
The command is an alias of the ipv6 route command with the predefined (default)
route:
ipv6 route ::/0
ipv6-address
|
interface-id
See the definition of the ipv6 route command for details.
Examples
Example 1. The following example defines a default gateway with a global IPv6
address:
switchxxxxxx(config)#
ipv6 default-gateway
5::5
Example 2. The following example defines a default gateway with a link-local IPv6
address:
switchxxxxxx(config)#
ipv6 default-gateway
FE80::260:3EFF:FE11:6770%vlan1
27.7 ipv6 enable
Use the ipv6 enable command in Interface Configuration mode to enable IPv6
processing on an interface.
To disable IPv6 processing on an interface that has not been configured with an
explicit IPv6 address, use the no form of this command.
Syntax
ipv6 enable
no ipv6 enable