EasyManuals Logo

Cisco 300 Series User Manual

Cisco 300 Series
1117 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #236 background imageLoading...
Page #236 background image
Clock Commands
OL-32830-01 Command Line Interface Reference Guide 236
9
Syntax
sntp anycast client enable [both | ipv4 | ipv6]
Parameters
• both—(Optional) Specifies the IPv4 and IPv6 SNTP Anycast clients are
enabled. If the parameter is not defined it is the default value.
• ipv4—(Optional) Specifies the IPv4 SNTP Anycast clients are enabled.
• ipv6—(Optional) Specifies the IPv6 SNTP Anycast clients are enabled.
Default Configuration
The SNTP anycast client is disabled.
Command Mode
Global Configuration mode
User Guidelines
Use this command to enable the SNTP Anycast client.
Example
The following example enables SNTP Anycast clients.
switchxxxxxx(config)#
sntp anycast client enable
9.9 sntp authenticate
To enable authentication for received SNTP traffic from servers, use the sntp
authenticate command in Global Configuration mode. To restore the default
configuration, use the no form of this command.
Syntax
sntp authenticate
no sntp authenticate

Table of Contents

Other manuals for Cisco 300 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 300 Series and is the answer not in the manual?

Cisco 300 Series Specifications

General IconGeneral
ModelCisco 300 Series
CategorySwitch
DimensionsVaries by model
WeightVaries by model
Power over Ethernet (PoE)Available on select models
ManagementWeb-based GUI, SNMP, CLI
VLANsUp to 256
Security FeaturesACLs, 802.1X, Port Security
Humidity10% to 90% non-condensing
Ports8, 16, 24, 48

Related product manuals