Cisco 300 Series User Manual

SSH Client Commands
943 OL-32830-01 Command Line Interface Reference Guide
48
Parameters
• string —Password for the SSH clients (1 - 70 characters). The password
cannot include the characters "@" and ":".
• encrypted-string —Password for the SSH client in encrypted form.
Default Configuration
The default password is anonymous.
Command Mode
Global Configuration mode
User Guidelines
If authentication is configured to use a password (using the command ip ssh-client
authentication), use the ip ssh-client password command to define the password.
If the encrypted keyword is used, the password must be in the encrypted form.
Use the command ip ssh-client change server password to change the password
on the remote SSH server so that it will match the new password of the SSH
client.
Example
The following example specifies a plaintext password for the local SSH clients:
switchxxxxxx(config)# ip ssh-client password &&&111aaff
48.5 ip ssh-client server authentication
To enable remote SSH server authentication by the SSH client, use the ip
ssh-client server authentication command in Global Configuration mode.
To disable remote SSH server authentication, use the no form of the command.
Syntax
ip ssh-client server authentication
no ip ssh-client server authentication

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48