Cisco 300 Series User Manual

IPv6 First Hop Security
OL-32830-01 Command Line Interface Reference Guide 514
25
Examples
Example 1—The following example defines the IPv6 First Hop Security policy
named policy1, places the switch in IPv6 First Hop Security Policy Configuration
mode, and enables logging of dropped packets:
switchxxxxxx(config)# ipv6 first hop security policy policy1
switchxxxxxx(config-ipv6-fhs)# logging packet drop
switchxxxxxx(config)# exit
Example 2—The following example removes an attached IPv6 First Hop Security
policy:
switchxxxxxx(config)# no ipv6 first hop security policy policy1
Policy policy1 is applied on the following ports:
gi11, gi12
The policy1 will be detached and removed, are you sure [Y/N]Y
25.23 ipv6 nd inspection
To enable the IPv6 Neighbor Discovery (ND) Inspection feature on a VLAN, use the
ipv6 nd inspection command in VLAN Configuration mode. To return to the default,
use the no form of this command.
Syntax
ipv6 nd inspection
no ipv6 nd inspection
Parameters
N/A
Default Configuration
ND Inspection on a VLAN is disabled.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48