Cisco 300 Series User Manual

Quality of Service (QoS) Commands
747 OL-32830-01 Command Line Interface Reference Guide
39
Syntax
show class-map [
class-map-name ]
Parameters
class-map-name—Specifies the name of the class map to be displayed.
Command Mode
Privileged EXEC mode
Example
The following example displays the class map for Class1.
switchxxxxxx(config)# show class-map
Class Map matchAny class1
Match access-group mac
39.6 match
Use the match Class-map Configuration mode. command to bind the ACLs that
belong to the class-map being configured. Use the no form of this command to
delete the ACLs.
Syntax
match access-group
acl-name
no match access-group acl-name
Parameters
acl-name—Specifies the MAC, IP ACL name., or IPv6 ACL name
Default Configuration
No match criterion is supported.
User Guidelines
This command is available only when the device is in QoS advanced mode.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48