Cisco 300 Series User Manual

Link Layer Discovery Protocol (LLDP) Commands
649 OL-32830-01 Command Line Interface Reference Guide
30
User Guidelines
Each port can advertise one IP address.
Example
The following example sets the LLDP management address advertisement mode
to automatic on gi12.
switchxxxxxx(config)# interface gi12
switchxxxxxx(config-if)# lldp management-address automatic
30.6 lldp med
To enable or disable LLDP Media Endpoint Discovery (MED) on a port, use the lldp
med Interface (Ethernet) Configuration mode command. To return to the default
state, use the no form of this command.
Syntax
lldp med {
enable [ tlv … tlv4 ] | disable }
no lldp med
Parameters
• enable—Enable LLDP MED
• tlv—Specifies the TLV that should be included. Available TLVs are:
Network-Policy, Location, and POE-PSE, Inventory. The Capabilities TLV is
always included if LLDP-MED is enabled.
• disable—Disable LLDP MED on the port
Default Configuration
Disabled
Command Mode
Interface (Ethernet) Configuration mode

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48