Cisco 300 Series

IGMP Snooping Commands
447 OL-32830-01 Command Line Interface Reference Guide
21
Example
The following example shows sample output:
switchxxxxxx# show ip igmp snooping groups vlan 1
21.17 show ip igmp snooping interface
To display the IGMP snooping configuration for a specific VLAN, use the show ip
igmp snooping interface command in User EXEC mode.
Syntax
show ip igmp snooping interface
vlan-id
Parameters
• vlan-id —Specifies the VLAN ID.
Command Mode
User EXEC mode
Example
The following example displays the IGMP snooping configuration for VLAN 1000
switchxxxxxx# show ip igmp snooping interface 1000
IGMP Snooping is globally enabled
IGMP Snooping Querier is globally enabled
VLAN 1000
IGMP Snooping is enabled
IGMP snooping last immediate leave: enable
Automatic learning of Multicast router ports is enabled
switchxxxxxx#
show ip igmp snooping groups
Vlan
----
1
Group Address
---------------
239.255.255.250
Source Address
----------------
*
Include Ports
------------
gi11
Exclude Ports
--------
Comp-Mode
---------
v2