Cisco 300 Series User Manual

Smartport Commands
OL-32830-01 Command Line Interface Reference Guide 838
44
Default Configuration
See User Guidelines.
Command Mode
Global Configuration mode
User Guidelines
The macro auto smartport command becomes effective only when the Auto
Smartport is globally enabled.
If both
smartport-type and interface-id are defined, the attached Smartport macro
is executed on the interface if it has the given Smartport type.
If only
smartport-type is defined, the attached Smartport macro is executed on all
interfaces having the given Smartport type.
If only
interface-id is defined then the corresponding attached Smartport macro is
executed if the interface has one of the following Smartport types: switch, router
or wireless access point (ap).
If a Smartport macro contains configuration commands that are no longer current
on one or more interfaces, you can update their configuration by reapplying the
Smartport macro on the interfaces.
Example
Adds the ports of Smartport type switch to all existing VLANs by running the
associated Smartport macros.
switchxxxxxx(config)# macro auto trunk refresh switch
44.4 macro auto resume
The macro auto resume Interface Configuration mode command changes the
Smartport type from unknown to default and resumes the Smartport feature on a
given interface (but does not reapply the Smartport macro; this is done by the
macro auto trunk refresh command).
Syntax
macro auto resume

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48