Cisco 300 Series User Manual

Quality of Service (QoS) Commands
OL-32830-01 Command Line Interface Reference Guide 754
39
switchxxxxxx(config-cmap)# match access-group ip1
switchxxxxxx(config-cmap)# exit
switchxxxxxx(config)# policy-map p1
switchxxxxxx(config-pmap)# class c1
switchxxxxxx(config-pmap-c)# set dscp 56
39.12 police
Use the police Policy-map Class Configuration mode. command to define the
policer for classified traffic. This defines another group of actions for the policy
map (per class map). Use the no form of this command to remove a policer.
Syntax
police
committed-rate-kbps committed-burst-byte [exceed-action action ]
no police
Parameters
• committed-rate-kbps —Specifies the average traffic rate (CIR) in kbits per
second (bps).(Range 100–10000000)
• committed-burst-byte —Specifies the normal burst size (CBS) in bytes.
(Range: 3000–19173960)
• exceed-action—Specifies the action taken when the committed rate is
exceeded. If the keyword is not configured then the drop action is applied.
• action —Specifies the action taken when the committed rate is exceeded.
The possible values are:
- drop—Drops the packet.
- policed-dscp-transmit—Remarks the packet DSCP. The remarking is
configured by the qos map policed-dscp command.
Default Usage
No policer
Command Mode
Policy-map Class Configuration mode.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48