Cisco 300 Series

50
OL-32830-01 Command Line Interface Reference Guide 971
System Management Commands
50.0
50.1 disable ports leds
To t u r n off the LEDs on all ports on a device, use the disable ports leds Global
Configuration mode command.
To set the LEDs of all the ports on the device to their current operational status of
the port, use the no disable ports leds command.
Syntax
disable ports leds
no disable ports leds
Parameters
This command has no arguments or keywords.
Default Configuration
The default is no disable port leds; that is the LEDs of all the ports reflect their
current status.
Command Mode
Global Configuration mode
Examples
The following example turns off the port LEDs.
switchxxxxxx(config)# disable ports leds