Cisco 300 Series

Ethernet Configuration Commands
OL-32830-01 Command Line Interface Reference Guide 406
18
Example
The following example displays the status of all configured interfaces.
switchxxxxxx# show interfaces status
Flow Link Back Mdix
Port Type Duplex Speed Neg ctrl State Pressure Mode
------ --------- ------ ----- -------- ---- ------ -------- --
gi11 1G-Copper Full 1000 Disabled Off Up Disabled Off
gi12 1G-Copper -- -- -- -- Down -- --
Flow Link
PO Type Duplex Speed Neg control State
----- ------- ------ ----- ------- ---- ------
Po1 1G Full 10000 Disabled Off Up
18.20 show interfaces advertise
To display auto-negotiation advertisement information for all configured interfaces
or for a specific interface, use the show interfaces advertise Privileged EXEC
mode command.
Syntax
show interfaces advertise
[interface-id | detailed ]
Parameters
• interface-id—(Optional) Specifies an interface ID. The interface ID can be
one of the following types: Ethernet port or port-channel.
• detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Default Configuration
Display for all interfaces. If detailed is not used, only present ports are displayed.