Cisco 300 Series User Manual

Line Commands
OL-32830-01 Command Line Interface Reference Guide 640
29
29.2 exec-timeout
To set the session idle time interval, during which the system waits for user input
before automatic logoff, use the exec-timeout Line Configuration mode command.
To restore the default configuration, use the no form of this command.
Syntax
exec-timeout
minutes [ seconds ]
no exec-timeout
Parameters
• minutes—Specifies the number of minutes. (Range: 0-65535)
• seconds—(Optional) Specifies the number of seconds. (Range: 0-59)
Default Configuration
The default idle time interval is 10 minutes.
Command Mode
Line Configuration Mode
Example
The following example sets the telnet session idle time interval before automatic
logoff to 20 minutes and 10 seconds.
switchxxxxxx(config)# line telnet
switchxxxxxx(config-line)# exec-timeout 20 10
29.3 line
To identify a specific line for configuration and enter the Line Configuration
command mode, use the line Global Configuration mode command.
Syntax
line
{console | telnet | ssh}

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48