Cisco 300 Series

IPv6 First Hop Security
OL-32830-01 Command Line Interface Reference Guide 512
25
no ipv6 first hop security logging packet drop
Parameters
N/A
Default Configuration
Logging is disabled.
Command Mode
Global Configuration mode
User Guidelines
Use this command to log packets that are dropped. If logging is enabled, the
switch sends a rate-limited SYSLOG message every time it drops a message.
Example
The following example shows how to enable logging of dropped packets by the
IPv6 first-hop security feature:
switchxxxxxx(config)# ipv6 first hop security logging packet drop
25.22 ipv6 first hop security policy
To define an IPv6 First Hop Security policy and place the switch in IPv6 First Hop
Security Policy Configuration mode, use the ipv6 first hop security policy
command in Global Configuration mode. To remove the IPv6 First Hop Security
policy, use the no form of this command.
Syntax
ipv6 first hop security policy
policy-name
no ipv6 first hop security policy policy-name
Parameters
• policy-name —The IPv6 First Hop Security policy name (up to 32
characters).