Cisco 300 Series User Manual

CDP Commands
OL-32830-01 Command Line Interface Reference Guide 202
8
Example
switchxxxxxx(config)# cdp run
8.2 cdp enable
The cdp enable Interface Configuration mode command enables CDP on
interface. The no format of the CLI command disables CDP on an interface.
Syntax
cdp enable
Parameters
N/A
Default Configuration
Enabled
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
For CDP to be enabled on an interface, it must first be enabled globally using cdp
run.
Example
switchxxxxxx(config)# cdp run
switchxxxxxx(config-if)# interface gi11
switchxxxxxx(config-if)# cdp enable

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48